Translations:Multifactor authentication/8/en

Download and install the YubiKey Manager software from the Yubico website.
Insert your YubiKey and launch the YubiKey Manager software.
In the YubiKey Manager software, select Applications, then OTP. (Images below illustrate this and the next few steps.)
Select Configure for either slot 1 or slot 2. Slot 1 corresponds to a short touch (pressing for 1 to 2.5 seconds), while slot 2 is a long touch on the key (pressing for 3 to 5 seconds). Slot 1 is typically pre-registered for Yubico cloud mode. If you are already using this slot for other services, either use slot 2, or click on Swap to transfer the configuration to slot 2 before configuring slot 1.
Select Yubico OTP.
Select Use serial, then generate a private ID and a secret key. Securely save a copy of the data in the Public ID, Private ID, and Secret Key fields before you click on Finish, as you will need the data for the next step.
IMPORTANT: Make sure you clicked on "Finish" in the previous step.
Log into the CCDB to register your YubiKey in the Multifactor authentication management page.